top of page
The Prince CenterLock* is the hub chosen by elite racers around the world! A super light hubshell, Ceramic- or Endurance-bearings and different types of freehub shells offer you countless customizing options. Each material was selected to achieve the lowest weight possible. The aerospace grade Aluminium with increased fatigue strength has been used to obtain the fine geometrical tolerances and the complex shape. The flange geometry has been optimized to increase the lateral stiffness of the wheel. Configure the hub you need: with Ceramic Bearings and 6Teeth Skyline Freehub to obtain a real Formula 1 or Endurance Bearings with Endurance reinforced freehub to switch the Rally mode on.


Available in all TUNE anodized colours! Please contact us for this request

TUNE Prince CL Rear Hub

Colour: Black
  • weight starting from: 183,9
    recommended spokes: SAPIM CX-Ray, SAPIM D-Light
    max. spoke tension 1100N
    max. rider weight: 90kg
    max.system weight: 105kg
    field of use: 24 holes for Road only, 28 and 32 holes for Road/Cx/Gravel/MTB (see "configuration" for more information)


    flange distance left: 32,4mm
    flange distance right: 19,2mm
    pitch circle left: 47mm
    pitch circle right: 57mm
    diameter spoke holes 2,4mm
    offset spoke hole left flange 1,5mm
    offset spoke hole right flange 1,5mm
    spoke lacing pattern: 24 spokes with 2-cross lacing or 28/32 spokes with 3-cross lacing
    Our tune spokelength-calculator will further help you to calculate the needed spoke lengths!


    configuration: Endurance Bearing with Endurance freehub body for CX-gravel-MTB/ Ceramic Bearing with Endurance freehub body for XC races only/ Ceramic Bearing with 6T. Skyline freehub body for Road only
    scope of delivery: hub and corresponding packaging if applicable
    notice: Remove the 1.8mm spacer on your freehub to switch from HG10 to HG11 and from XD to XDR.
    Remove the two spacers (1.8mm and 0.6mm) on your freehub to switch from HG10 to HG12. 
    Please note that this hub with 6 Teeth freewheel is not approved for use with 1by groupsets. If you want to use the hub with a 1by groupset, please choose the Endurance or Standard freewheel.
    Screw on the lockring and tighten it with max. 40Nm.
    for more information please refer to the user manual
    *XD-Compatible licensed by SRAM
    *XDR Compatible licensed by SRAM
    *center lock rotor mounting system licensed by Shimano
    *microspline system licensed by Shimano
    *N3W is a Campagnolo registred trademark

bottom of page